ASSEMBLY AND OPERATION INSTRUCTION OF EXHAUST
EXHAUST systems are directly related to the performance and power of engine. Therefore, it is necessary to make a correct application of assembly and use.
THE RULES TO BE IMPLEMENTED:
1-The fasteners on the vehicle should be used properly, and in the assembly of products any fastener except for pipe clip system should not be used.
2-For an appropriate assembly, it is necessary to pay attention that all the components of the exhaust system have the same brand.
3-Exhaust systems should not be considered as just a pipe that exhales burnt gas in the engine, and it should not be forgotten that exhaust is a component of the engine. The measurements of exhaust are determined as a result of long-lasting trials and engineering studies in order to work with the engine in an appropriate way. Therefore, extentions and reductions should not be performed during the exhaust fitting to the vehicle in order not to impair the originality of the system.
4- The effect of muffler on the engine power: As a result of the tests, it is determined that use of appropriate muffler in the vehicles has increased the efficiency of engine. By replacing the old muffler with the original muffler:
At 3000 rpm the increase in the engine power is 1.0 HP (Horse Power).
At 4000 rpm the increase in the engine power is 5.2 HP (Horse Power).
How to get the maximum efficiency from your Vehicle and Engine:
Have your exhaust checked in the nearest service station every 6 months. Do not drive with burst and damaged exhaust.
Do not forget that the burst and damaged exhaust will reduce the power of your engine in other words increase the consumption of gas.
We have now large bodied end seaming machine from Germany and 150 mm CNC tube bending machine.As now we are producing for Mercedes Benz Aksaray plant, the silencer system for Axor trucks type 1840 and 3340.
Our investments continue very fast...
New tools in the pipe production section were completed at the end of 2003. With the introduction of the tools of 50 and 55, we had the possibility of manufacturing pipes with 16 different diameters. With regard to the investments of this year, hydraulic guillotine and seam welding machine have been replaced with the new ones.
Our company is in operation with the conditions of TS EN ISO 9001:2000 Quality System Document which had been obtained in January 2004, beginning the works of ISO/TS 16949:2002 Quality Management System which has a vision of the main system to provide the continuous improvement and the defect prevention that are both formed by the inclusion of special requirements, and aiming to be certified by the end of 2004, by enhancing the targets furthermore.
